newtronics Shelf Gate 5.1 Floorstanding Empress Temperance Drivers Tweeters/Bass Drivers Amplifiers Main Amp

newtronics

Sub 15/100 - Low Bass Subwoofer For Home Cinema

Technical data:
- output: 105/210 Watt continuous/programme
- frequency range (-8dB): from 24 Hz
  upper crossover frequency adjustable,
- maximum SPL (1m): 111 dB
- Size (HxWxD): 59.4 x 45.4 x 65.4 cm
- Speaker type: bass reflex, 127 litre
- impedance: 4 Ohm

More and more customers require high output subwoofers for their home cinema. This is an extremely solid subwoofer with high output.

The Sub 15's bass driver is the solidly built Newtronics Sub 15. The driver comprises:

  • an extremely solid die cast basket
  • double ventilated voice coil
  • a surround of 40 mm
  • a drive system adequate for low bass
  • an impedance of 4 Ohm, ideal for exploiting the amplifier's capabilities
  • gold plated terminals
    Newtronics Sub15

    Located on the rear side of the subwoofer is the amplifier module RCM DT 105


    Frequenzgang
    The frequency response (pictured right) with infinitely variable crossover frequency (to be done on the module); blue line: at 100 Hz crossover frequency, red line: 60 Hz. Should the bass a be a bit tighter and go down a bit further down (at reduced volume), we recommend to extend the bass reflex tube by 4 cm using folded paper.

    The kit contains:
    - a Newtronics Sub 15 bass driver
    - a Detonation DT 105 amplifier module
    - 2 HP100 bass reflex tubes, pointing down
    - 1/2 pack nap foam N25
    - 8 Allen wood screws 5x30mm
    - 12 wood screws Pan 4x20
    - sealing tape MDM-5
    - the building instruction
    Newtronic Sub 15/100 kit (without cabinet)   - not available

    Sub 15 building instruction
    Home