The baffle consists of one panel with 16 mm and one with 22 mm thickness. These panels are glued together. Inside, there is a bracing panel with two cut-outs to ensure free airflow. The rear panel has to be cut-out to accommodate the subwoofer module. Four holes have to be cut-out in the bottom panel for the bass reflex tubes.
All panels are going to be screwed together (and glued, if required). Afterwards, the amplifier module and the drivers are going to be fitted.
Finally, the feet are going to be mounted. The distance to the floor determines the tuning of the subwoofer, since this is an extension to the bass reflex tubes. Should you want to place the subwoofer close to a corner, then the distance to the floor may be reduced by 5 mm.
The bottom panel as well as the panel above the second bass driver should be lined with nap foam.
The bass driver should be fitted last.
The low bass characteristics of the DT500 are adjustable. We recommend, however, to try the neutral factory setting first. To us this seems to be the best compromise between low bass and volume.
We are sure you will enjoy this great subwoofer. - Should have further questions please give us a call at +49-721-9703724.
Possible modification: If required the cabinet may designed with 10 cm more depth. The bass reflex tubes remain the same. This results in 2-3 Hz more bass.
Sub 25 Description Home