Home Closed Cabinet Bass Reflex Cabinet LspCAD Lite Volume Calculator

 
Closed Cabinet
 Q factor Qts to be entered with two decimals
Please enter decimal separators as "."
------------------------------ Driver ------------------------------- -------- Loudspeaker ------
Resonance frequency
fs in Hz:		 Equivalent volume of
compliance Vas in litre:		 Total driver Q factor Qts: total Q factor Qtc:
Recommended: 0.71
 
Volume in litre: 1)
Cut-off frequency f3 (-3dB) in Hz:
Cut-off frequency f8 (-8dB) in Hz:
Efficiency in dB (1W/1m):
1) Calculation is only for damped speakers. Non-damped speakers should be 20% bigger.
The original formulas kindly provided by Manfred Hoffbauer, mh-audio.
Copyright © Iris Strassacker, 2003, 2004. All rights reserved - Warranty excluded

Total Q factor Qts correction
Resistors, cables or a coils that are being used to connect a loudspeaker show a DC resistance. This DC resistance has an influence on total Q facto Qts and, therefore, needs to be considered. The following calculator makes it a little bit easier for you; the result is automatically entered into to calculator at the top.

Qts correction calculator
(Qts-Correction)		 Q factors Qes, Qms to be entered with two decimals
Please enter decimal separators as "."
------------------------------ Driver ------------------------------- ----- Crossover, Cable -----
Electrical Q factor Qes: Mechanical Q factor Qms: DC resistance Re: Coil's DC resistance R ... in Ohm:
Qts old of driver only:
  Qts new with cable, coil, ...:
All formulas kindly provided by Manfred Hoffbauer, mh-audio
Copyright © Iris Strassacker, 2003, 2004. All rights reserved - Warranty excluded

Print this page     Home